Subcategories
Easy to useDriver voltage: 5-10VForce variation output: voltage signalSize: 12.7 x 12.7 x 75mm
Material: Experimental Board + Mixed AlloyColor: BlackChip Module: CP2102Working Temperature: -40 ℃ ~ +125 ℃Power Input: 4.5V ~ 9V (10VMAX), USB-poweredDrive Type: Dual high-power H-bridge driverCurrent: continuous transmission ≈70mA (200mA MAX)
Supply voltage: 3.2V~5.5V. (If the module you want to work long hours in the emission state, it is recommended that when the supply voltage exceeds 4.5V threaded a 1N4007 diode to prevent module built-in LDO heated) Default idle current: 16MA (In different working modes operating current is different) Operating frequency range: 433.4-473.0MHz, up to 100...
Name: ADXL345 module (three-axis acceleration of gravity) Model: GY-291 Using a Chip: ADXL345 Power supply: 3-5V Communication mode: IIC / SPI communications protocol Measuring range: ± 2g ± 16g
Supports all MCU control The industrial field PLC control Smart home control
LCD display module with yellow backlightWide viewing angle and high contrastBuilt-in industry standard HD44780 equivalent LCD controllerCommonly used in: copiers, fax machines, laser printers, industrial test equipment,networking equipment such as routers and storage devices
The WeMos D1 mini V2 is minimal ESP8266 wifi board. The D1 mini is a mini wifi board based on ESP-8266EX. Board size: 34.2mm*25.6mm More infos here: http://www.wemos.cc
. 1 RPi firmware and raspi-config has been updated to the camera , do a apt-get update; apt-get upgrade;2. Raspi-config , select the camera, start RPi firmware camera driver, and then restart3 Use the command-line program raspivid and raspistill operate the camera to capture video clips or images4 to capture video clips need to play with mplayer
Double H bridge drive Chip: L298N (ST NEW) Logical voltage: 5V Drive voltage: 5V-35V Logical current: 0mA-36mA Drive current: 2A (MAX single bridge) Storage temperature: -20 to +135
Module Operating voltage: 4.8V-5.5V Typical current: 1.6mA Size: 2.9 x 1.7 x 0.4cm Typical operating current: <1.7mA, shutdown current: <1μA Operating voltage range: 2.6V ~ 5.5V
Infrared sensor with control circuit board The sensitivity and holding time can be adjusted Working Voltage Range: DC 4.5V- 20V Current drain:<60uA Voltage Output: High/Low level signal:3.3V TTL output Detection distance: 3--7M(can be adjusted) Detection range: <140° Delay time: 5-200S(can be adjusted, default 5s +-3%)
A single module can drive an 8 x 8 common cathode lattice Operating voltage: 5V Size: 5 x 3.2 x 1.5 cm (L x W x H) LED color: red With four screws hole, aperture 3mm With input and output interfaces, supports multiple modules cascade
An excellently paired combination of high-efficiency propellers and ultra-fast motor, USAQ coreless motors provide the speed you need for your next brushed drone build. Reliable performance combined with exceptional value makes USAQ coreless motors and excellent choice for micro FPV racing drones.
Car regulator, solar photovoltaic, wind power and other applications of voltage instability .
It’s an open-source single-board computer. It can run Android 4.4, Ubuntu, Debian, Rasberry Pi Image. It uses the AllWinner H3 SoC, and has 512MB DDR3 SDRAM